Sorry, you need to enable JavaScript to visit this website.

Network FMC card - Industrial Ethernet

Zedboard forums is currently read-only while it under goes maintenance.

Unsolved
5 posts / 0 new
bbhatt
Junior(0)
Network FMC card - Industrial Ethernet

Hi,
I am a novice and have currently started working with the microzed industrial ethernet kit. 
I was able to run the ethercat demo version on the board using the network fmc module, however, I would like to change/set the destination MAC address to a particular value.
 
Any suggestions on where the changes should be made?
I am using EC Engineer as master device and after sending the data on the microzed board, I want to change the destination MAC address and send the received data to that set address.
 
Thanks.

JFoster
Moderator(76)
Hello,

Hello,

Could you please link the Network FMC card you are using?

--Josh

bbhatt
Junior(0)
I am using ISM Networking FMC

I am using ISM Networking FMC module 2 (https://www.xilinx.com/products/boards-and-kits/1-420hwd.html).

JFoster
Moderator(76)
Hello,

Hello,

Could you please link the Network FMC card you are using?

--Josh

bbhatt
Junior(0)
I am using ISM Networking FMC

I am using ISM Networking FMC module 2 (https://www.xilinx.com/products/boards-and-kits/1-420hwd.html).